Calibration is done by looking at the output of a DOA while adjusting the offset trimmer pot. Each DOA has a DC Servo with offset adjustment, and a few jumpers associated with it:
JPx01 – Servo control on/off
JPx02 – DOA input or ground
DOA Pre Stage left:
Put a jumper on JP201 in the ‘S ON’ position. This enables the servo. You want no input to the preamp, so put a jumper clip on JP202 ‘Gnd’. This grounds the input to the DOA through a 4.99k resistor. Clip your meter leads to TP201 and ground. Put the meter on its lowest DC Volts scale. Leave it for 5 minutes. You need the OPA227PA to warm up. When you come back, see what the meter says; it could be anything, or nothing. If the meter is reading a voltage, adjust RV202 in one direction, give it a few seconds, and see if the meter reading goes up or down. If it goes up, turn RV202 in the opposite direction. You want the reading to be zero millivolts. If your meter goes down to microvolts, make that zero. When you have it as low as it can go, move the shorting plug on JP202 from ‘Gnd’ to ‘Input’.
DOA Pre Stage right:
Repeat the steps above substituting JP301, JP302, TP301 and RV302 for the names above.
DOA Buffer Stage left:
Repeat the steps above substituting JP601, JP602, TP601 and RV601 for the names above.
DOA Buffer Stage right:
Repeat the steps above substituting JP701, JP702, TP701 and RV701 for the names above.
At the end of this process, you should have no DC voltage on the volume control or the preamp outputs/power amplifier inputs.
The levels must be set with the RV201 and RV301 pots. The procedure is fairly simple.
If you know the sensitivity of your power amp, substitute that value for the 1.999Vrms above. Your levels should be correct for most setups. If you have access to an oscilloscope, you can adjust the outputs to a point where your power amp is just about to clip. Do it with no speakers attached!. I would back it down a turn or so just to be safe. Now, in theory, you can turn the volume all the way up and it should not clip.
Copyright ©2000 - 2026 David Allmon All rights reserved. | Privacy Policy | Cookie Policy